SportIdent

BS7-P Printout Station

The station allows users to read-out, save and evaluate data stored in SportIdent finger-sticks. Auto-on behaviour when any SI-Card (finger-stick) is inserted. Integrated RS232 interface with DB9 connector. Cable length of 1.5m Internal backup memory up to 1022 SI-Cards Print results function with automatic sort into different courses Custom print layout of header, footer and code-number translation is possible using software SI-Print Internal lithium battery works 4 to 7 years. http://www.sportident.ca/archive/2010/02/02/what-the-printer-control-does.aspx Click here for an article on what this device can do.
$455.00

BS8-D Time Master

The SI-Master BS8-D is an extended SI control. In addition to being able to be programmed by you like any other control, it can also be used as a Time Master, and as an Extended Time Master. A Time Master allows the quick setting of the real-time clocks in other controls. As Extended Time Master it additionally clears the backup memory of the other controls. See the downloads section below for more info.
$220.00

BSF7-D

A universal orienteering control station. It can be programmed to the following modes: Clear / Check / Start / Finish or numbered control.
$148.00

BSF8

The BSF8 Timing Control comes as either a "display top" (DT) unit or a "display bottom" (DB) unit. This distinction refers to the location of the LCD readout on the control - either on the top or the bottom of the unit. In general, if a control is to have a control code sticker on its top surface, the "display bottom" unit is recommended. The DB unit is available in blue or red. The DT unit is available in blue only.
$145.00

BSM-7-D-RS232

Serial Port based main station Allows programming of controls, downloading of fingerstick information
$168.00

BSM-7-USB

Main station with USB interface to computer. Allows programming of controls and downloading of finger-stick information See the downloads section below for a document describing the features of this control.
$158.00

BSM8-D-USB

Download station with USB interface to computer. Allows programming of controls and downloading of finger-stick information. This unit does not contain an internal battery, it is powered by the USB port. It features very low power consumption, the laptop battery will not be stressed. The unit will retain all downloads even if the unit is unplugged for a while.
$152.00

ComCard Pro

Moscompass compass with built-in SI-10. Choose your compass module and orientation (left vs right).
$128.00

ComCard Up

Moscompass compass with built-in SI-8. Choose your compass module and orientation (left vs right).
$100.00

Coupler

This coupler is needed to enable communication between a USB or RS232 main station and a control. Insert the coupler into the hole of the main station and lay the control on top of the main station. The control will send the RF signal from the one control to the other.
$3.50

Enduro Set

This is a complete set to handle the timing for Enduro races. Your event can have up to 5 stages (and more can be added with extra control stations), and the racers will record the time on timing cards that every biker carries with him/her. As soon as the biker arrives at the finish, the timing data can be downloaded and published. The timing cards are reusable. Extra timing cards are available. Please contact us. Custom designed cards can be arranged. The Enduro set includes the following items: 50 timing cards (pCards 5 Start and 5 Finish timing controls 1 time master to prepare the timing cards and quickly synchronize the timing controls 1 USB timing card reader 1 coupling stick, 1 Service/Off management finger-stick
$2,650.00

Mounting holder (plate) for BS7

This mounting plate grips the end of the BS3-BS7 control on both ends but is as wide as the entire control. Comes with small bolts, washers and nuts. Not theft-proof.
$3.75